HOW TO FIT RUNNERS FOR INTERNAL TANDEMBOX DEEP
|
|
|
|
This page shows the quickest and easiest way to mark out and fit runners for your drawer box. |
If you would prefer to watch a video of this procedure, click here
|
 |
|
With the drawer box assembled, you are now ready to fit the packer and runners- Some general observations for fitting the internal deepTandembox
- The 25mm packer supplied with your kit goes on the hinge side of your unit, and allows the drawer to clear the hinges
- To assist with the positioning, please note that the bottom of the packer lines up with the bottom of your drawer box
|
|
|
|
 |
|
- Decide on the position of your internal drawers using the following factors
- Equally space them in the unit if you have 3 or 4
- Space them in the unit depending on what will be stored - eg cereal boxes/tins/etc
- PLEASE NOTE the following instructions show how to fit the drawer directly into the bottom of the base unit
- For any other position, please refer to the instructions to fit the runners for the shallow internal Tandembox here
|
|
|
|
 |
|
- Simply lay the packer directly on to the base of your unit with the front of the packer 5mm back from the front edge of the unit
- Put in the three screws and secure the packer in position
|
|
|
|
 |
|
- Lay the runner on the base of the unit and line up the front of the runner flush with the front of the packer
- Mark 4 holes in pencil
|
|
|
|
 |
|
- Start these holes off using a screw, dont go in all the way, just enough to locate the screws
|
|
|
|
 |
|
- Put the runner back in place and secure with 4 screws
- Make sure the screws do not go in at an angle, as this can snag the drawer
|
|
|
|
 |
|
- Lay the opposite runner directly on to the base of the unit and bring the front 5mm back from the front edge of the unit
- Fit the runner using the same method as above
|
|
|
|
 |
|
- With the runners in place, you can now fit the drawer
- With the runners fully retracted inside the unit, lay the box onto the runners approx 25% of the way in
- Push the box downward and in toward the back of the unit
- The box should click into place in the runner and locate itself
- Installation is complete
|
|
|
|
|
|
|