Length of drawer sides and runners required : 500mm (Requires 505mm)
Excellent units, I ordered the set, but in the end I only used 2 where I intended, I cut down the third and used it elsewhere.
.
Leo Maxwell. 8/12/2025 at 13h11
Length of drawer sides and runners required : 500mm (Requires 505mm)
Fitted like a dream.
John W. 8/5/2025 at 08h24
Length of drawer sides and runners required : 450mm (Requires 455mm)
Product quality is excellent but a few niggles. 1. Difficult to decipher which part went with which size ordered as no clear labelling and some parts of different sizes were bundled together. 2. Lowest unit drags on bottom of cabinet. Needs 5mm of clearance, rather than following advice to install flush to base. 3. the edging on the chipboard was not applied on unseen edges. 4. Boards should be pre-drilled as slightly misaligned screws pulls drawers apart, worsened by countersunk screws.
Michael W. 7/28/2025 at 20h56
Thanks for the feedback and positive review. Please note..
The bottom drawer will certainly work with the runners directly on the base. We have assembled this way many hundreds of times. Please ensure there are no screws or debris under the runner.
Correct; - only visible exposed edges are edged. This is standard practice industry wide.
When inserting individual screws it is advisable to start in the dead centre (OR TO THE INSIDE) which will pull the join tighter rather than apart. We do show in video and written instructions the shortcut of starting each hole slightly with a screw.
Drawerboxes.co.uk 7/28/2025 at 21h23
Length of drawer sides and runners required : 500mm (Requires 505mm)
Product quality is excellent but a few niggles. 1. Difficult to decipher which part went with which size ordered as no clear labelling and some parts of different sizes were bundled together. 2. Lowest unit drags on bottom of cabinet. Needs 5mm of clearance, rather than following advice to install flush to base. 3. the edging on the chipboard was not applied on unseen edges. 4. Boards should be pre-drilled as slightly misaligned screws pulls drawers apart, worsened by countersunk screws.
Michael W. 7/28/2025 at 20h56
Thanks for the feedback and positive review. Please note..
The bottom drawer will certainly work with the runners directly on the base. We have assembled this way many hundreds of times. Please ensure there are no screws or debris under the runner.
Correct; - only visible exposed edges are edged. This is standard practice industry wide.
When inserting individual screws it is advisable to start in the dead centre (OR TO THE INSIDE) which will pull the join tighter rather than apart. We do show in video and written instructions the shortcut of starting each hole slightly with a screw.
Drawerboxes.co.uk 7/28/2025 at 21h23
Length of drawer sides and runners required : 270mm (Requires 275mm)
I love them. They not only look great, they slide beautifully and are very easy to use. Very happy and definitely impressed with them.
Sue S. 7/25/2025 at 15h34
Thanks for a great review!
Drawerboxes.co.uk 7/25/2025 at 15h37
Length of drawer sides and runners required : 450mm (Requires 455mm)
Perfect fit.
Christopher C. 7/20/2025 at 17h30
Length of drawer sides and runners required : 500mm (Requires 505mm)
Excellent quality drawers and rhe pack provided all the compinents needed to install without changing the hinges.
The drawers operate very smoorhly and feel robust.
Paul S. 7/16/2025 at 07h45
Length of drawer sides and runners required : 450mm (Requires 455mm)
Works ok. Instructions terrible.
Gethin c. 7/13/2025 at 00h34
Thanks for the review. We also have video instructions on YouTube (links on product page) if the written instructions are not on a clear copy. The written instructions for each product are also on the website.
Drawerboxes.co.uk 7/13/2025 at 22h07
Length of drawer sides and runners required : 450mm (Requires 455mm)
Perfect.
Christopher C. 6/24/2025 at 17h24
Length of drawer sides and runners required : 450mm (Requires 455mm)
Not as well built as the older style Tandembox but that seems almost impossible to get hold of. This is nothing against Drawbox more about Blum.
Fits together ok.
Slides in and out ok.
Simon C. 6/9/2025 at 10h31
Thanks for your review. In our opinion, the Antaro version of the Tandembox is the best all round balancing appearance and use. There is of course the lifetime warranty indicating Blum are rightly confident in their latest version.
Drawerboxes.co.uk 6/11/2025 at 20h14
Length of drawer sides and runners required : 500mm
Apart from the instructions for the runners being incorrect, these are excellent products, well made and easy to assemble.
These are quite wide drawers at 800mm and I was a little concerned that the bases might sag in the centre, so I added small angle brackets at the rear, but I may be being overly cautious.
Leo M. 5/20/2025 at 10h33
Length of drawer sides and runners required : 400mm
Well made and delivered promptly. Easy to put together and fit.
Anthony W. 4/22/2025 at 14h30
Length of drawer sides and runners required : 450mm
Good quality product, works very well. There was an update to the side packers which wasn't shown on the you tube instructions but was easily worked out without need to contact the seller. A very easy build and install, basic DIY skills is all that's required
Everything needed was in place, all parts and screws required.
I would have no problem using this company again.
Donald F. 4/18/2025 at 20h01
Length of drawer sides and runners required : 500mm
Prompt service with someone available on the phone when needed. Good quality but a little difficult to fix.
Thomas H. 4/13/2025 at 11h43
Length of drawer sides and runners required : 500mm
Excellent.
WENDY M. 2/25/2025 at 13h34
Length of drawer sides and runners required : 450mm
Good design requesting email instructions was useful for assembly.
Peter A. 2/2/2025 at 16h14
Length of drawer sides and runners required : 450mm
Superb quality drawers. My kitchen fitter was as delighted with them as I was, saying they were easy to build and of top quality.
David W. 1/22/2025 at 17h43
Length of drawer sides and runners required : 450mm
Excellent.
Nigel C. 1/17/2025 at 07h31
Length of drawer sides and runners required : 500mm
Lovely concealed units for that added storage.
Jordan O. 12/20/2024 at 00h33
Length of drawer sides and runners required : 500mm
Nice strong product. These were retro fitted to a cupboard that I was sick of trying to fish stuff out of the back.
Packers worked well round hinges.
Hannah C. 11/10/2024 at 20h50
Length of drawer sides and runners required : 450mm
Very good product but having asked for instructions on installin the units to be sent by email I did not receive them .My builder carried out the installation .
David L. 11/6/2024 at 12h14
Length of drawer sides and runners required : 500mm
Fantastic quality and service.
LR. 11/2/2024 at 09h32
Length of drawer sides and runners required : 450mm
Excellent quality product, video build guide makes easy work of putting the drawers together giving a very solid finish.
Debbie S. 10/14/2024 at 16h55
Length of drawer sides and runners required : 450mm
The boxes were easy to put together and the runners were quite easy to install. Only one issue. The 5mm rebate was not enough for my Wren kitchen cupboard hinges which needed 13mm. Hence I had to reinstall the runners.
Roger L. 8/18/2024 at 00h22
Thanks for the review. Our packing strip can be notched if required to miss the edge of a hinge plate.
Drawerboxes.co.uk 8/19/2024 at 15h51
Length of drawer sides and runners required : 500mm
Well made.
Clive G. 7/17/2024 at 10h41
Length of drawer sides and runners required : 450mm
We're very happy with the set of 3 internal drawers we'd ordered to be fitted inside a tall pantry -- to such an extent that we've just ordered another set of 3. Brilliant, very-well made product.
Barbara O. 6/7/2024 at 19h28
Length of drawer sides and runners required : 500mm
Not as easy to install as you portray on videos.
Barbara O. 5/14/2024 at 18h56
Thanks for the feedback. The lad in our videos is an experienced installer, but he has shown the installation exactly as it should be done with nothing missed out or shortened. We have sold many hundreds of these packs, and receive regular positive feedback on the quality of the product and the You Tube installation videos.
Drawerboxes.co.uk 5/14/2024 at 18h06
Length of drawer sides and runners required : 450mm
Quality product, well engineered, easy to assemble and fit. I retro fitted this to a 300mm cupboard - using a right-angle drive and short drills to make pilot holes it was a straightforward project.
Michael C. 5/7/2024 at 13h07
Length of drawer sides and runners required : 450mm
The Blum internal Antaro drawers, while expensive, (but then what kitchen components are not) are great and of excellent quality. They are designed for existing kitchen base units to convert them into drawer units using the existing carcass and door. This makes getting at items in the cupboard far easier; no need to get on your knees to search for something at the back anymore.
Stuart J. 4/24/2024 at 08h28
Thanks for a great review. There is also the Blum Lifetime Warranty which gives peace of mind for future durability.
Drawerboxes.co.uk 4/24/2024 at 13h47
Length of drawer sides and runners required : 450mm
Very nicely done.
Mohanlal U. 4/11/2024 at 13h15
