Err

ENQUIRIES 01289 466101 (7 days)
Need help measuring? Text any photos to 07801703093
quality drawers made for any space
HOW TO FIT DRAWER FRONT ON TANDEMBOX SHALLOW
This page shows the quickest and easiest way to mark out and fit your drawer front

If you would prefer to watch a video of this procedure, click here



Tools and materials required.
  • Your drawer front
  • Complete drawer box kit
  • Measuring tape
  • Set square or similar
  • Pencil
  • Cordless drill driver or equivalent
  • Completed drawer box is in position
  • The position of the top holes on the fixing brackets have to be transferred onto the drawer front

  • Measure from the outside of the base unit to the centre of the top hole on the fixing plate
  • For your reference, this size should be around 33mm
  • Lay your drawer front as shown with the inside top marked in pencil
  • REMEMBER to deduct the side clearance before marking the drawer front
  • Just to clarify, the side clearance is 4mm because the unit is 500mm wide and the drawer front is 496mm wide
  • This 4mm is halved to give 2mm clearance per side
  • Mark the line on your drawer front as shown
  • Measure from the underside of the worktop to the centre of the top hole on the fixing plate


  • REMEMBER to deduct the top clearance before marking the drawer front
  • To clarify, the top clearance is usually 4mm - 5mm
  • Mark the line on your drawer front as shown
  • You are now ready to attach the fixing plates to the drawer front
  • The fixing plates must be removed from the drawer sides
  • First remove the plastic covers by pulling from bottom corner as shown
  • Using Phillips screwdriver follow instructions below
  • Push screwdriver in until the small sprung plate moves up as shown
  • This exposes the full crossed slot allowing you to push screw driver in
  • Now twist clockwise as shown
  • As you twist clockwise, the plate should move out then fully release
  • Repeat the same on the other side
  • You can now fit the plates to the drawer front
  • Place the plate as shown with the holes in position over the pencil marks
  • Screw the plate into position using the 15mm screws supplied
  • Repeat for the other plate
  • You are now ready to attach the drawer front into the drawer sides
  • With the drawer box slill in position in the runners proceed as below
  • Hold the drawer front as shown and line up the plates 
  • Push the drawer front into the sides until both sides click into place
  • With the drawer front now in position, you can check the clearance all round and decide on adjustments required
  • See below for procedure to adjust your drawer front.
  • Drawer front can be adjusted as shown in photo
  • When you are happy with adjustments and drawer front clearance, click the plastic covers back into place as shown.
  • The drawer box installation is now complete and you can re-fit the handle or knob.